Machine parts of TP40 roof sheet tile press Trapezoidal metal roof tile making machine01. Mainframe: GB H steel, hard texture.02. Operator station: 360-degree rotation display.
03. Cutter: The main material is Cr12, which has high hardness.
04. Retaining pad: Prevent the nut from loosening.
05. Easy hanging: Prevent the machine from scratching during the movement.
06. Wheel: generally 45# steel, good hardness.
07. Travel switch: Limit the position or travel of the machine.
08. Rear hand knife: cut in advance to prevent waste.
09. Resin wheel: used to record the length of discharge and record data is more accurate.
10. Electric control cabinet: The main motor and PLC are famous brands.

Decoiler

Common machine with 5 tons manual decoiler, or you also can choose electric decoiler or hydraulic decoiler.

1. The main body of TP40 roof sheet tile press trapezoidal metal roof tile making machine with water-proof plastic, then fixed to container by 8mm diameter steel wire and angle iron. 2. Rollers and shafts are covered with anti-rust oil. 

3. PLC control system and motor pump are packed with waterproof paper and plastic film. 

4. Spare parts in a carton box. 

5. Manual decoiler was nude packing.

6. The output-table put into a carton box.

7. If the TP40 roof sheet tile press trapezoidal metal roof tile making machine is too long, we will divide it into two parts and pack them in one package with steel wire. 

8. Fit for ocean shipping.